Description
A neat and easy solution for fitting an L Plate to a Honda CB125R 2018+. It bolts securely into existing points on the bike – no modification required.
In the box:
– 3D Printed L Plate holder (New Design*, as shown in image 4)
– 2x M5x40mm bolts.
– 2x Cable Ties for securing L Plate to mount.
– 2x M5x40mm bolts.
– 2x Cable Ties for securing L Plate to mount.
The L Plate is not included – works with any standard size (178mm wide) hard plastic L plate up to 1.5mm thick.
Fitting Instructions:
– Remove the two bolts from the back shell of the digital display with a 5mm hex key. Keep the these bolts safe for when it’s time to loose the L plates.
– Mount the L plate holder into the two holes and secure using the provided bolts with a 3mm hex key. Tighten to 5Nm. This is not much – be careful to not over tighten.
– Create two small (~4mm) holes in the L plate aligning with the holes in the bottom corners of the mount.
– Fit the L Plate into the mount and use the two cable ties to secure it in place.
– Mount the L plate holder into the two holes and secure using the provided bolts with a 3mm hex key. Tighten to 5Nm. This is not much – be careful to not over tighten.
– Create two small (~4mm) holes in the L plate aligning with the holes in the bottom corners of the mount.
– Fit the L Plate into the mount and use the two cable ties to secure it in place.
The mount is 3D Printed in recycled (post Industrial) PETG plastic – it will not warp in outdoor use or fade in sunlight.
*While the old design was perfectly fit for function on the bike, it didn’t always survive the Royal Mail. The new design looks identical on the bike, but removes weak points that could break if mishandled in transit. Despite being marginally (20g) heavier, it’s also easier to print, so reduces overall material waste due to misprints.
Reviews
There are no reviews yet.